Installation steps of roadway gate chassis

Installation steps of roadway gate chassis

Installation steps of roadway gate chassis 

The installation steps of the roadway gate chassis are as follows:
1. Before installing the barrier gate, the installation location should be selected according to the following aspects:

The ground of the barrier gate should be on the same plane as the installation surface. After the installation location is determined, the barrier gate foundation should be prepared according to the site conditions. The non-concrete ground should be the cast-in-place foundation. Bolt on.

2. Install the chassis:

Mark out six expansion screw positions, use a 23mm drill bit to drill expansion bolt holes, the hole depth is about 110-120mm, and insert expansion bolts, adjust the level and verticality of the box, and tighten the nuts.